Wind Dust Network main purposes: fuel particulate coal field, coking plants, power plants and other places more for fuel waste reduction; for carrying supplies ports, terminals and other more and more places, can reduce the dust raised; with on roadsides, can reduce wind speed and reduce the impact of cross wind caused when the vehicle is turning; for the environmental protection industry, can reduce the haze, dust storms and other weather incidence. Design strength: Under normal circumstances, the pressure 750Pa, wind speed 30m / s, equivalent to under 12 gust intensity, you can use more than 20 years. Sheet thickness also determines the length of life, usually after plate by high voltage electrostatic spraying thickness up to 0.5-1.3mm. Dust Mechanism: Wind Dust Network is the use of aerodynamics, processed into a certain geometry in accordance with the implementation of on-site wind tunnel experiments, the opening ratio and different combinations of wind and dust shaped hole wall, air circulation (strong wind) from the outside through the wall, the wall formed inside the air flow to achieve outside of the interference of strong winds, the inside of the weak wind, outside of the small wind, no wind, the effect of the inside to prevent dust emissions. Appearance Category: singlet, doublet, triplet triplet common specifications: Width 85-95cm Twin Peaks: 80-90cm single peak: 45cm in length can be customized 6M Wind Dust Network of five series: (1) ordinary cold-rolled steel as the base material, sheet thickness 0.5mm-1.5mm, the CNC punching equipment, molding, and then double-sided high-voltage electrostatic powder coating surface anti-corrosion treatment. (2) as the base material galvanized steel, sheet thickness 0.5mm-1.5mm, punching, molding by the numerical control device, and then double-sided high-voltage electrostatic powder coating the surface anti-corrosion treatment. (3) as a base material with painted steel, sheet thickness 0.5mm-1.5mm, punching, molding by the numerical control equipment. The surface treatment is not required. (4) using galvanized steel as a base material, sheet thickness 0.5mm-1.5mm, the CNC punching equipment, molding. It does not require surface treatment (5) as a base material with a stainless steel plate, sheet thickness 0.5mm-1.5mm, the CNC punching equipment, molding, no surface treatment.